Electronic floor scales are very commonly used. They are easy and convenient to use, versatile and suitable for different occasions. Therefore, they are preferred by the majority of users.
However, when the electronic floor scale is used, improper use or human or external factors may cause the electronic floor scale to malfunction.
Five common errors and solutions in electronic floor scales:
1. When weighing electronic floor scales, the ones on the monitor numbers displayed are unstable.
Solution: First check whether the electronic floor scale is on a horizontal surface and whether the four scale feet are level and adjustthe position of the electronic floor scale and the scale feet are new.
2. When the electronic floor scale is turned on, the display shows numbers and jumps irregularly.
Solution: In this case, the moisture in the connection box of the floor scale is often too high or water has penetrated. You should quickly dismantle the junction box to check whether water has entered and blow dry it with a hair dryer.
3. After the electronic floor scale is switched on normally, the weighing result is too light or too heavy.
Solution: At this time, you need to perform a recalibration according to the user manual.
If the problem with the electronic floor scale is still not resolved after calibration, it can generally be assumed that the sensor of the floor scale is damaged.
4. After the weighing is completed, the display returns to Entremoving the weighing object still does not return to zero.
Solution: The above situation should be caused by signal attenuation due to line damage. Check carefully whether the data line of the electronic floor scale is damaged. If yes, it should be replaced in time.
5. After switching on, the display of the electronic floor scale does not respond.
Solution: Carefully check whether the power cord and monitor cable are intact. If you find any damage, replace it immediately.
If there is no problem with the line connection, it can only be assumed that there is a problem with the motherboard or hardware of the monitor. At this time, the only option is to contact the manufacturer and send it back to the factory for repair.