Welcome to Qinsun Instruments Co., Limited.
- +86-21-6780 0179 |
- info@qinsun-lab.com |
- Customer Services
With mechanical stirrers, the stirrer rotates in the stirring container to stir the liquid. This is a common method for dispersing gas, liquid or solid particles into the liquid in chemical production.
Installation and maintenance of the mechanical mixer:
Maintenance of the machine:
1. The bearing supports the Responsibility of the machine The entire load, so good lubrication has a great connection with the life of the bearing, which directly affects the service life and operating rate of the machine;
Therefore, the injected The lubricating oil must be clean and sealed. It must be in good condition.
The main oil filling points of this machine are (1) rotating bearings (2) roller bearings (3) all gears (4) moving bearings and sliding planes.
2. Newly installed wheel tires tend to come loose and need to be checked regularly.
3. Pay attentionf whether all parts of the machine are working properly.
4. Be sure to check the degree of wear of slightly worn parts and replace worn parts at any time.
5. Dust and other materials should be removed from the lower shelf level where the movable equipment is placed to prevent the movable bearing on the lower shelf from moving when the Machine hitting materials that cannot be moved will break, which may result in serious accidents.
6. If the temperature of the bearing oil increases, stop the vehicle immediately to check and eliminate the cause.
7. If a knocking noise is heard when operating the rotating gear, stop the machine immediately for inspection and eliminate it.
Installation and commissioning:
1. The device should be installed on a horizontal concrete foundation and secured with anchor boltsbe strengthened.
2. Pay attention to the verticality of the main body and horizontality when installing.
3. After installation, check whether the screws in various parts are loose and whether the main engine compartment door is tight. If yes, please tighten it.
4. Configure the power cord and control switch according to the performance of the device.
5. After completing the inspection, carry out a no-load test run. If the test run goes normally, production can begin.
Machine maintenance is an extremely important and regular task. It should be closely coordinated with extreme operation and maintenance, and full-time personnel should be deployed for inspection.
