Operating Specification for Rain Test Box

The rain test box is suitable for external lighting and signal devices, as well as the protection of car lamp casings. It can provide realistic simulation of various environments that electronic products and their components may be subjected to during transportation and use, such as water and spray tests. To achieve testing of the waterproof performance of various products.H9UTextile Testing Instruments, Testing Equipment Manufacturer
The operating instructions for the rain test box are as follows:H9UTextile Testing Instruments, Testing Equipment Manufacturer
first, connect the power supply, then turn on the power switch, and the power light will be on;H9UTextile Testing Instruments, Testing Equipment Manufacturer
This indicates that the controller will automatically enter the fixed value stop interface;H9UTextile Testing Instruments, Testing Equipment Manufacturer
1. When the control program set by the machine is completed after turning on the power, the machine will stop running;H9UTextile Testing Instruments, Testing Equipment Manufacturer
2. When the set control program is completed, the machine will stop running;H9UTextile Testing Instruments, Testing Equipment Manufacturer
3. Open the handle of the box door and place the test sample on the sample rack; Then close the box door; Attention: The capacity for placing samples should not exceed 2/3 of the capacity of the testing area;H9UTextile Testing Instruments, Testing Equipment Manufacturer
4. According to the TEMI880 operation manual, first perform the test setting operation, and then enter the testing state according to the set operation mode.H9UTextile Testing Instruments, Testing Equipment Manufacturer
5. If you want to observe the changes inside the box during the test, you can turn on the door light switch, and the internal changes can be learned through the window. The temperature and humidity changes inside the test box will be displayed on the controller (if there are no humidity requirements during the test, the humidity value will not be displayed);H9UTextile Testing Instruments, Testing Equipment Manufacturer
6. Open the handle of the box door, take out the test sample from the sample rack, inspect the tested sample, and record the test status; This test is completed; 7. After testing, turn off the power switch P/pH9UTextile Testing Instruments, Testing Equipment Manufacturer