Martindale pilling tester

info@qinsun-lab.com Get Quote

The Martindale pilling tester can test the wear resistance and pilling performance of various structured fabrics. The sample undergoes low-pressure continuous directional friction with a certain friction material, and the degree of wear and pilling can be compared and evaluated with standard parameters. The instrument adopts a movable sample fastening component, which can remove a friction sample at any time without affecting other samples. It not only achieves rapid and independent detection of the sample, but also ensures the accuracy of friction measurement during the same period. It is a recognized fastening method in BS EN ISO12947-1:1999. This instrument is equipped with an electronic preset processing timer and total counter, sample clamp and load device (in compliance with international testing standards), and can provide models with 4, 6, 8, and 9 heads.

Compliant with standards:

ISO 5470, DIN 53863/53865, BS 3424/5690, IWTO 40-88, BS EN 388/530, IWSTM 112/196, ASTM 4966/4970, IS 12673, JIS L1096, SFS 4328, PR EN ISO 12947-1, PR EN ISO 12945-2, SATRA TM31, ISO 20344

Applicable scope:

It can detect the wear resistance and pilling performance of various plants. Under a certain pressure, the sample is subjected to continuous directional friction with the designated abrasive, and the degree of wear and pilling is evaluated by comparing it with standard parameters. Touch screen control, equipped with a comprehensive programmer, capable of pre programming batches and total counts, and setting the count for each test head separately; Four speeds, including standard speed, can be selected.

Technical indicators:

1. Number of working hours: 4, 6, 8, 9Heads

2. Touch screen display

3. Weight of pressurized material a. Clamp: 200 plusmn; 1g; b. Weight of fabric sample: 395 plusmn; 2g; c. Furniture and decoration sample weight hammer: 594 plusmn; 2g; d. Stainless steel disc: 260 plusmn; 1g

4. Effective friction diameter of grinding block: A-type 200g (1.96N) friction head yen; 28.8-0.084mm; B-type 155g (1.52N) friction head yen; 90-0.10mm

5. Relative movement speed between gripper and grinding table: 47.5 r/min

6. Sample pressing hammer mass: 2385 plusmn; 10g

7. Power supply: 220V 50Hz

Instrument configuration and consumables:

1. 9 sets of sample clips;

2. 9 weights of 9Kpa and 12KPa each;

3.Phi; 38mm Phi; One set of 140mm samplers each;

4.Phi; 38mm Phi; One 140mm sampler pad each;

5. A set of pilling test kits;

6. One set of SM50 standard samples;

7. One set of EMPA standard pilling samples and one piece of SM-25 standard grinding cloth 1.6m x 5m;

8. One set of standard foam 1.5m times; 0.5m (4 pieces/set);

9. A standard felt piece;

10.Phi; 20 90mm felt discs;

11.Phi; 38mm Phi; 50 140mm sampler blades each;

12. Other essential accessories recommended by the manufacturer.