About> two test steps
Abrasion Resistance and Pilling Martindale Abrasion Resistance
Martin The Dyer Abrasion Pilling Tester is the standard method for determine the abrasion and pilling resistance of textiles or leather.
Here are two test steps for Martindale.
1. Martindale wear test
1.1 Test bench installation.
1.2 Place the installed sample holder assembly on the wear-resistant table and fix it with 1 bolt. Place the weight (12Kpa or 9Kpa), choose according to the standard.
1.3 Positioning pinhole changes.
1.4 Setenter the test cycle and speed shown on the left.
1.5 Click on TEST to start.
1.6Martindale Fabric Abrasion Tester> automatically stops after reaching the test period and observes the sample.
2. Martindale pilling test
2.1 Place the pilling sample container on the wear-resistant test bench, then place a 260g weight and close the top
Cover. Secure it with 1 bolt.
2.2 Changes in positioning pin holes.
2.3 Set the test cycle and speed shown on the left.
2.4 Click on TEST to start.
2.5Martindale Pilling Tester> automatically stops after reaching the number of tests to observe the sample.