Austius The rug six -leisure tester has a wide range of use, because it meets many test standards at home and abroad, such as: IOS 26844, ISO 10361, ASTM D5252, ISO 9405, etc. So you can cope with multiple detection methods. Then the following editors will introduce the working principles and operation steps of the Ao Tengs carpet six -legged roller tester. >
1. Working principle >
Carpet six -legged roller tester The working principle of the working principle is not complicated. The principle is to place the carpet sample on the inner wall of the drum. At the same time, a hexagonal test block is placed in the interior. Rolling the surface of the sample. After a certain number of times, take out the carpet sample to evaluate the changes in the surface structure and color changes of the carpet surface according to the relevant standards. To judge the appearance of the carpet. >
2. Operation steps > 1. Turn the lid against the counterclockwise until the small concave hole Align the concave holes on the drum, take out the lid.
2. Install the carpet sample in the inner wall of the drum to ensure that the lining plate is fixed in a fixed slot in the inside of the turning drum.
3. Check
Polyurethane nails of hexagonalClean, smooth and without any pollution, if necessary, wipe with paper and suitable solvents to wipe Essence > 4. Put the hexagonal into the drum, the concave holes are aligned, and the lid is rotated clockwise until tightened.
5. Connect the power supply and turn on the switch on the power socket. Select the standard test mode according to the sample conditions, and then press the Run/Stop key to start the test.
If it is not tested in accordance with the ISO 10361 standard, select the custom mode test, set the corresponding rotation and interval.
6, 2000 After the end , the machine issued a stoppage alarm, took out the installed sample and placed it in the central hole of the cleaning frame. Use a vacuum vacuum cleaner to make it along the length direction of the installation of the samples four times to ensure that all areas pass through all areas and pour the fluff once.
7. SampleThe total number of procedures is repeatedly reached to the total number of the following procedures:
4000 rpm, simulating the use of early appearance changes or less severe wear positions.
12000 rpm, simulation of severe wear for long -term use;
8. Use Vacuum cleaner
Clean again by (6) steps. 9. After adjusting the sample alone, flat, and fluffy, it is rated according to the corresponding standards. >
Note: Every time the test is done, please clean the inside of the drum to prevent the debris from entering the bearing and cause equipment damage.
Carpet six -legged drum tester
, also known as: six -legged drum wear test machine, six -legged drum tester, six -legged drum testing instrument. It is suitable for testing all carpet products that need to be evaluated, and observe the changes in the surface structure and color of the carpet under the action of hexagonal mechanical methods. The appearance capacity used to evaluate the long -term use of carpets. It is a professional testing instrument that evaluates the appearance and durability of textile carpet. It is a very widely used product.
>