Welcome to Qinsun Instruments Co., Limited.
- +86-21-6780 0179 |
- info@qinsun-lab.com |
- Customer Services
Standard Name:
IEC 60695-11-10fire Hazard Testing-PART 11-10: Test Flames-50 WHORIZONTAL and Vertical Flame Test Methods IEC 60695-11-10 Fire Danger Test. Part 11-10: Test Flame: 50W level and vertical flame test.
Standard range:
This section specifies comparative plastic and other non -other A small laboratory screening method of a relative combustion characteristic of metal material sample
. The briefing source of the test is a small flame with a nominal power of 50W, and the test sample is horizontally or vertically placed.The above experimental method except the linear combustion rate and residual flames of the sample. It is suitable for solid materials and the method of determining the ISO 845 method at a foam plastic with a density of less than 250kg/m3. Essence
Experimental Principles:
One end of a strip -like test sample, the sample is horizontal or vertical, vertical state The free end is contact with the prescribed experimental flames. Use the method of linear combustion to evaluate the combustion characteristics of strip -shaped samples supported by horizontal support, and use the method of measurement of residual flames and burning time, flame particles and the degree of dripping. Burning characteristics.
Experimental significance: 
In the test method A, which is the horizontal burning HB, try The horizontal position of the sample is particularly suitable for the speed of evaluation of the degree of combustion and / or the spread of flames, that is, the rate of linear combustion. In the test method B, which is vertical combustion V, the vertical position of the test sample is particularly suitable for the combustion after evaluating the flame of the test flame.
1. Product use:
This tester is suitable for inspection and evaluation of the combustion characteristics of plastic materials. It is based on the US UL94 standards according to the US UL94 standard The relevant clauses specified in the Combustic Test of the Plastic Materials for Equipment and Equipment and Materials, and the plastic parts of the equipment and appliances are horizontal,Vertical combustible test
, and configure the configuration There are gas flowmeters, regulating the size of the flame, and using a motor to drive, and the operation is simple and safe. Comply with standards: UL94, GB / T2408, IEC60695-11-4, GB / T5169.22, IEC60695-11-3, GB / T5169.15, IEC60695-10, GB / T 5169.16, UL60065.
horizontal combustion test machine is a sample bar to be tested horizontally, placed horizontally After ignition, it is horizontal burning. The vertical combustion test machine is placed vertically by the sample bar to be experimented. The horizontal combustion focuses on the combustion time of flame retardant samples, and vertical combustion is more focused on dripping the flame retardant sample. Many fires are caused by dripping. For example, when the curtains are burned, the materials are dripping on the carpet and furniture, which will cause a greater fire.
This tester is suitable for the combustion characteristics of inspection and evaluation of plastic materials. Made in the level of plastic parts of equipment and appliances,
vertical flammable test , and equipped with gas flowmeters, regulating the size of the flame, using a motor to drive, the operation is simple and safe. In addition to meeting the GB / T5169.22-2015 standards: UL94, GB / T2408, IEC60695-11-4, IEC60695-11-3, GB / T5169.15, IEC60695-10, GB / T 5169.16, UL60065, etc. Wait for test standards.
