VW60330 standard is the German line standard, and most companies around the world are recognized and referenced by reference. In the test standard, the Australian terminal section analyzer also meets this standard.
1. Open crushing sleeve
as an open crusher sleeve, wire pressure connection, insulation pressure, or single -wire sealing pressure connection (ELA) Use U, V or Pre -shaped to open the mark. Developed pressure connections are obviously using stamping terminal components. During the pressure, the development of the development of the development of the development of the purse is closed at the same time and cut the muscles. It is Cross -section analyzer Commonly used ways. >
2. Closed crushing sleeve
Use a closed contours of wire pressure connection, insulation pressure or single -wire sealing pressure Pressure -connecting tube. Obviously, the tube type pressure connector is used. The closed crusher sleeve is the principle of wire pressure connection. The single -line sealing pressure connection or insulation pressure connection of a closed crusher holder requires a lot of consumption, so it is rarely used.
3, the wire requirements
Only the light -recognized light or surface treatment of the single copper thread is allowed, according to the VW60306 standard clearly clear Point out that it is not used for solid -core wires, aluminum wires, or flat wires, and the wire is not tin or welded.
Materials that affect their conductive properties such as harmful gases or oxygen aging are not allowed in the wires.
Provide a sufficient proof that the wires can continue to be used for more than two years and their materials must meet the standard parts of the VW60306 and the corresponding lines.
Product introduction: > AOTSI-QC100 fully automatic
The terminal section analyzer is a precision detection and analysis equipment specially developed for the quality inspection of the wiring beam industry. The collection system, wire beam terminal picture measurement analysis and other systems are composed of cutting and grinding integrated equipment, new patented technology, and the one -time completion of cutting and grinding, which completely ensures the flatness requirements of the terminal. The cutting and grinding split machine equipment adopted by our company has been updated (after cutting, the fixture is removed until the grinding equipment grinding does not guarantee the flatness of the terminal and cannot be accurate to determine the grinding accuracy). A full set of detection systems can complete a terminal within 5 minutesThe processing analysis has greatly improved the speed of the end of the terminal section. The operation is simple and convenient, fast, and adopts an imported high -definition image acquisition system and a precise measurement analysis to escort your production. >
The main characteristics ① The resin solidification method that does not require resin to so far must be grinded from the resin hardening ⇒ resin. It takes about 30 minutes to make a sample. This product does not require resin solidification. It only takes 5 minutes to make a sample.
② Dedicated fixture of the terminal can correspond to the newly developed fixtures of various sizes. Do not worry about grinding cable teeth or flying out of the wire when grinding. No special skills can be operated easily. Auxiliary standard fixture can correspond to the wire of the AWG8 ~ AWG26. > ※ The fine line fixture (AWG26 ~ AWG36) can be added ※ Special fixture of the resin solidarity sample (which can be clipped in large diameter ø23mm) can be added.
③ High -performance microscopic observation and special software can quickly and correctly measure the length and calculate area. The magnification rate is 26 times more to 260 times. The extremely fine lines exceeding AWG30 can also be displayed clearly. The measurement accuracy at a large rate is 5 μm.