Welcome to Qinsun Instruments Co., Limited.
- +86-21-6780 0179 |
- info@qinsun-lab.com |
- Customer Services
Made of stainless steel, the self-priming pump features simple and reliable structure and is durable. Under normal conditions, the pump generally does not require frequent disassembly and maintenance.
If an error is detected, it can be fixed at any time.
1. There are several main parts to consider when servicing the pump:
a. Roller bearings:
After the pump has been in operation for a long time, the bearings must be replaced if they are worn to a certain extent.
b. Front O-ring, Rear O-ring:
When the O-ring wears to a certain extent, it must be replaced.
c. Mechanical seal:
In general, the mechanical seal should not be disassembled if it is not leaking?
Check. If there is severe leakage from the leakage port at the bottom of the bearing body, the mechanical seal should be disassembled for inspectionearth.
When assembling and disassembling the mechanical seal, be careful with it, pay attention to cleaning the mating surface, protect the mirror surface of the static ring and moving ring, and strictly prohibit knocking and collision.
The main reason for the mechanical seal leaking is the brushing of the mirror surface due to friction.
The repair method is to grind the friction end face to restore the mirror surface.
Another reason for the mechanical seal to leak is that the “O” shaped rubber sealing ring (or cushion) is improperly installed or has become deformed and aged. At this point it will be necessary to adjust or replace the o-ring for reassembly.
2. Pump disassembly sequence:
a. Remove The motor could detach from the coupling.
b. remove dFor the bearing body assembly, check the radial clearance between the impeller and the front ring and check if the impeller nut is loose. /p
c. Remove the impeller nut, pull out the impeller and check the radial clearance between the impeller and the rear O-ring.
d. Loosen the tight ring of the mechanical seal. Pull out the moving ring portion of the mechanical seal, check the seating of the moving and static ring end faces, and check the “O” ring (or cushion) seal.
e. Unscrew the clutch adjustment nut and pull out the clutch.
f. Remove the bearing end cover and remove the pump shaft and bearing.
g. Assembling can be done in reverse order when installing.
The above is the maintenance and disassembly method of I hope the self-priming stainless steelpump is helpful for everyone.
