The metal pulling machine adopts the design of mechatronics, which mainly consists of load cell, transmitter, microprocessor, load driving mechanism, computer and color inkjet printer.
You may not know much about the maintenance and upkeep of the metal tractor. Below we tell you about the maintenance and upkeep of the metal tractor. Let's take a look.
Metal traction machine maintenance and maintenance methods:
1. Check the bolts on the jaws regularly, and tighten them in time if they are loose.
2. The sliding surface between the clad steel plate and the liner plate and the dovetail groove surface on the liner plate should be kept clean, and a thin layer should be regularly applied molybdenum disulphide grease;
3. Periodically check the sprocket transmission. If you looseunit, please tighten the tensioning wheel.
Maintenance of Oil Well of Metal Tensioner:
1. Regularly check whether there is any oil leakage from the main motor and oil well If oil leakage is detected, should the sealing ring or the combination cushion can be replaced in good time.
2. Depending on the usage of the machine and the life of the oil, the oil needs to be replaced Suction filter and filter element should be replaced regularly, and the hydraulic oil should be replaced;
3. Be sure to turn off the power of the main motor if you don't do the test for a long time.
When the machine is in the standby state, the transfer switch should be set to the load position, because when the transfer switch is turned to the fast reverse position, the electromagnet will be activated Reversing valve is always energized, which affects dthe lifespan of the device.
Metal Tractor Control System Maintenance:
1. Periodically check that the connecting wires on the back of the controller are making good connections . Fasten in time;
2. If the machine is not used for a long time after the test, turn off the controller and the computer;
3. Controller There is a one-to-one correspondence between the interfaces of the controller, and the wrong interface may cause damage to the device.
4. The controller must be powered off when plugging or unplugging the interface on the controller.
The above is the relevant introduction to the maintenance and servicing of the metal tractor;
The equipment operator should carefully read and understand the maintenance and servicing instructions to maintain the equipment , Take good care of the instrument, keep the instrument clean and tidy, the parts andAccessories complete and safe and ensure the normal operation of the instrument.