Welcome to Qinsun Instruments Co., Limited.
- +86-21-6780 0179 |
- info@qinsun-lab.com |
- Customer Services
Electric heaters for high-pressure reactors can be divided into three types, each targeting a different heating position, and the heating effect is also different.
One of them is to use the flange-type tubular high-pressure reactor electric heating device, and its electric heating element is inserted upside down into the high-pressure reactor jacket to heat the heat transfer oil, heat energy can be applied to the effectively transfer reactor. The chemical raw materials in the high-pressure reactor ensure that it reaches the required temperature to meet the needs of the reaction.
There is also internal heating type high pressure electric reactor heater, which insert electric tube heating elements directly into the high pressure reactor, or electric heating tubes are evenly distributed on the wall. This type of electric heater for high-pressure reactors not only heats up quickly, soChange also has high efficiency, so it is very popular.
The other is the deep red electric heater of the high-pressure reactor, that is, the electric heater envelops the bottom, middle and lower parts of the high-pressure reactor for heating.
Because this type of device has the characteristics of large heating area, stable and rapid temperature rise, even heat output, and convenient temperature control, it can be controlled in sections from the top, middle and lower, thereby the high-pressure reactor is manufactured. The temperature of the inner boiler wall is easy to control.
Related maintenance of high pressure electric heater reactor:
1 The operation and use must be strictly according to the specified working pressure and working temperature on the nameplate of the product so as not to cause any danger.
2 Strictly adhere to the propositionRefer to the product's user manual for cooling and other aspects, and do a good job of maintaining and maintaining the equipment.
3 When using all valves, the valve stem (needle) should be rotated slowly to push the tight cover and achieve the sealing effect. Do not use too much force when closing to avoid damaging the sealing surface.
4 The control instruments should be operated by special personnel, and overload protection devices should be set up according to the regulations.
5. Installation should be done on a firm and flat workbench. The height of the workbench depends on the use. There must be a certain clearance around the device and workbench for installation, and later maintenance. .
6 When installing, the gear shaft must be perpendicular to the ground, and the slope of non-perpendicularity must not be more than 1/1000 of Ge
7 Equipment The closed parts at each process connection and the safety valve of the reactor must be equipped according to the requirements of the reactor.
8 After completing the installation, check the strength and reliability of the connecting parts and transmission parts, and conduct an airtightness test on the connecting pipes, nozzles, gaskets and the whole machine. Drop , Leak Phenomenon.
