Welcome to Qinsun Instruments Co., Limited.
- +86-21-6780 0179 |
- info@qinsun-lab.com |
- Customer Services
Separating funnel speed control oscillator is safe and easy to operate, stepless speed control and vertical rotation are stable. It is an indispensable experiment for scientific research, teaching and production departments of plants, biological products, genetics, viruses, medicine, environmental protection, etc. Room decoration.
The vertical workbench is equipped with a special device that can accommodate a variety of test bottles and vibrate and stir evenly under the same conditions.
It is particularly suitable for the cultivation and preparation of biological samples for various comparison tests.
Separating funnel oscillator maintenance
Proper use and attention to the maintenance of the instrument to keep it in good working order can prolong the life of the life of the instrument.
During the dhowDuring the operation of the instrument, a periodic inspection should be carried out every three months: check for water droplets, dirt, etc. falling on the motor and control unit.
Check fuses, controls and fastening screws.
The gear unit bearings were filled with an appropriate amount of grease (#1 calcium-sodium based) before leaving the factory. During the continuous operation of the instrument, the fat remains. Addition should be made every six months. The filling quantity is approx. 1/3 of the storage space.
The instrument has been used for a long time and natural wear and tear is a normal phenomenon.
If after using the instrument for one year, you find that the motor makes abnormal noise, the bearing of the gear part is worn, the belt is loose or broken, or the electronic control component fails...etc.
Maintenance
Proper useing and paying attention to the maintenance of the instrument to keep it in good operating condition can prolong the life of the instrument.
During continuous operation of the device, a regular inspection should be carried out every three months: check for water drops, dirt, etc. falling on the motor and controls. Check the fuse, controls and tighten screws.
The gear unit bearings were filled with an appropriate amount of grease (#1 calcium-sodium based) before leaving the factory. During continuous operation of the instrument, grease should be present and topped up every six months. The filling quantity is approx. I/3 of the storage room.
The instrument has been used for a long time and natural wear and tear is a normal phenomenon.
