Welcome to Qinsun Instruments Co., Limited.
2023-04-03 0 Views

Common mistakes and solutions when using tensile testing machines

Common Tensile Testing Machine Errors and SolutionsZo6Textile Testing Instruments, Testing Equipment Manufacturer

Zo6Textile Testing Instruments, Testing Equipment Manufacturer

In the daily operation of the tensile testing machine There are many problems due to various external or internal wear and tear of the machine. The most common are as follows:
1. A prompt appears after the computer software is online overloading the information display.

The solution is to check if the communication line between the computer and the test machine is disconnected; to check whether the online selection sensor is correctly selected; to check Last test or the sensor when operating theKeyboard Whether it was triggered Check whether the calibration or calibration function of the software was used before the problem occurs Check whether the calibration value, the calibration value or other information in the hardware parameters was changed manually.

2. The main power of the test machine is off and cannot move up and down.
The solution is to check whether the power line connected to the tester is connected normally; whether the supply voltage is normal; check if the fuse is on The machine socket is burned out, please take out the spare fuse and install it.

3. The main power of the testing machine is on, but the equipment cannot move up and down.
DThe solution is to check if the device cannot be moved after 15 seconds (time) because the host has to do a self-check when it is powered on. and it takes about 15s; check the upper and lower limits, whether the position is in the right position and there is a certain space for operation; check whether the power supply voltage connected to the testing machine is normal.