1. Connect the power first, turn on the power switch, the power supply indicator light is on.
2. It has to wait 15 minutes and wait for the Tension machine presets It can be connected to the computer according to the thermal stability.
Then we need to choose the right size Install the load sensor and fix the sensor, set the required test speed and press the zero button on the display to make it show zero.
Install the device connecting rod and activatethe path switch 1 Files. Adjust the Coarse Adjust knob so the panel gauge reading is zero, then press the 50 gear. Adjust the Fine Adjust knob so the display gauge reads a zero condition .
Press the Calibration block of the range switch around Adjust the Calibration button. Adjust the reading on the gauge to match that indicated on the small transmitter panel and finally press the Zero switch. Install the upper fixture to clamp the sample, clamp the lower fixture, and then press the 50 range, adjust the fine adjustment button so that the reading on the gauge is zero. Press the break on the force gauge power button, set rangedamping and Test Speed and then turn on the recorder paper speed and then press the Down button on the speed unit panel to test.
After a pattern has been tested, it must be operated in the following order, and the operation process must be careful.Press the ZERO button on the meter display. Press the stop button on the speedometer.