Welcome to Qinsun Instruments Co., Limited.

Protective clothing acid and alkali resistance test equipment

info@qinsun-lab.com Get Quote

  • Protective clothing acid and alkali resistance test equipment is used to determine acid and alkali impermeability of permeable acid and alkali protective clothing.7vCTextile Testing Instruments, Testing Equipment Manufacturer
      7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Application:7vCTextile Testing Instruments, Testing Equipment Manufacturer
    GB 24540-2009 protective clothing for acid and alkali chemicals.7vCTextile Testing Instruments, Testing Equipment Manufacturer
    7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Working principle:7vCTextile Testing Instruments, Testing Equipment Manufacturer
    The resistance of the test solution to penetrate the fabric is expressed by the hydrostatic pressure of the fabric. Under the atmospheric pressure of 101.325kPa, the lower surface of the sample bears a continuously rising liquid pressure. Until there are three seepage points, and record the height of liquid column at this time, which is called hydrostatic pressure resistance of fabric.7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Protective7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Technical Parameters:7vCTextile Testing Instruments, Testing Equipment Manufacturer
    1. Test solution: 80% concentrated sulfuric acid with different concentrations of acid and alkali7vCTextile Testing Instruments, Testing Equipment Manufacturer
    2. Rising rate of acid fracturing test solution: (60 3) cm/min7vCTextile Testing Instruments, Testing Equipment Manufacturer
    3. Maximum pressure: 150mm liquid column Maximum acid pressure: more than 150mmH2SO4(80%)7vCTextile Testing Instruments, Testing Equipment Manufacturer
    4. Measuring range: 0 ~ 150 mm liquid column 0 ~ 0~150 mmH2SO4(80%%)7vCTextile Testing Instruments, Testing Equipment Manufacturer
    7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Preparation:7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Three samples were taken from the finished protective clothing, with a diameter of 32 mm.7vCTextile Testing Instruments, Testing Equipment Manufacturer
    7vCTextile Testing Instruments, Testing Equipment Manufacturer
    Steps:7vCTextile Testing Instruments, Testing Equipment Manufacturer
    1. the reagent contacts the sample from vertically below7vCTextile Testing Instruments, Testing Equipment Manufacturer
    2. Continuously and stably pressurize the reagent7vCTextile Testing Instruments, Testing Equipment Manufacturer
    3. Observe the sample and record the hydrostatic pressure when the third liquid bead appears on the sample7vCTextile Testing Instruments, Testing Equipment Manufacturer
    4. Each sample shall be tested three times, and the static pressure value of the sample shall be obtained by taking its arithmetic mean value.

Get a Quote

Your email address will not be published. Required fields are marked *