Welcome to Qinsun Instruments Co., Limited.
2023-01-11 0 Views

What Is The Rubber Din Abrasion Tester Gt-kb03 ?

What is The Rubber DIN Abrasion Tester GT-KB03 ?aDxTextile Testing Instruments, Testing Equipment Manufacturer

aDxTextile Testing Instruments, Testing Equipment Manufacturer

DIN Abrasion Tester is used to determine wear performance test of materials like elastic material, rubber, tires, conveyor belts, conveyor belts, shoe soles.aDxTextile Testing Instruments, Testing Equipment Manufacturer

aDxTextile Testing Instruments, Testing Equipment Manufacturer

Test Principle:aDxTextile Testing Instruments, Testing Equipment Manufacturer

Rubber abrasion tester under certain touching pressure and contact area, sample becomes a certain angle with sandpaper and determine its abrasion performance caused by a certain level of sandpaper. Packsandpaper outside the surface of roller. The sample is pressed against the roller with sandpaper, which makes sample lateral moving along roller. Abrasion is caused under the other side of cylindrical specimens measuring the mass loss of sample value and count the wear amount by sample density.aDxTextile Testing Instruments, Testing Equipment Manufacturer

aDxTextile Testing Instruments, Testing Equipment Manufacturer

Din Abrader Standards:aDxTextile Testing Instruments, Testing Equipment Manufacturer

aDxTextile Testing Instruments, Testing Equipment Manufacturer

DIN-53516, JIS-K6369, JIS K6264-2,IOS 20991 section 8.3,IOS 20265, GB20266-2006, IOS 9867, EN ISO 20344-2020 section 8.3, AS/NZS 2210.2 section 8.3, ISO 4649, BS903-A9 Method A, ASTM D5963, ISO20871, QB/T2884, EN 12770aDxTextile Testing Instruments, Testing Equipment Manufacturer

aDxTextile Testing Instruments, Testing Equipment Manufacturer

Testing Methods:aDxTextile Testing Instruments, Testing Equipment Manufacturer

1. Sampling with a cutter.aDxTextile Testing Instruments, Testing Equipment Manufacturer

2. Open the safety cover.aDxTextile Testing Instruments, Testing Equipment Manufacturer

3. Weigh the sample before rubber abrasion testing.aDxTextile Testing Instruments, Testing Equipment Manufacturer

4. Install the sample to the test head, and then use the height adjustmentdevice to make the sample protrudes 2 mm in height.aDxTextile Testing Instruments, Testing Equipment Manufacturer

5. Fix the sample and lock the nut. Measure the height ofsample by the tool again, and then loosen the nut.aDxTextile Testing Instruments, Testing Equipment Manufacturer

6. Raise the test head and move it to the far left.aDxTextile Testing Instruments, Testing Equipment Manufacturer

7. Load the weights needed(for example, load a 2.5N, then total weight is 5N).aDxTextile Testing Instruments, Testing Equipment Manufacturer

8. Close the safety cover.aDxTextile Testing Instruments, Testing Equipment Manufacturer

9. Clear the current times and set the cycles.(42cycles=20m,84cycles=40m)aDxTextile Testing Instruments, Testing Equipment Manufacturer

10. Turn on the vacuum cleaner.aDxTextile Testing Instruments, Testing Equipment Manufacturer

11. Start testaDxTextile Testing Instruments, Testing Equipment Manufacturer

12. Machine will stop automatically when it reaches the setting, then test end.aDxTextile Testing Instruments, Testing Equipment Manufacturer

13. Remove the sample, check the test results, and weigh the sample.aDxTextile Testing Instruments, Testing Equipment Manufacturer